2023 John Deere 3032E

• Standard four-wheel drive(4WD) for maximum traction

• Hydro transmission with Twin Touch™ pedals for ease of use

• On-board diagnostics including Service Advisor

• Category 1 3-pt hitch compatible with dozens of implements

Features may include:

• Economical cast-in-block cylinder design for good cooling and long life

• Direct fuel injection

• Improves starting

• Injects fuel directly on top of pistons for more efficient combustion

• Develops more horsepower per liter (gallon) of fuel than indirect injection engines

• Aluminum alloy pistons are lightweight to reduce connecting rod bearing loads and provide good heat transfer characteristics

• Design permits tighter tolerances and neutralizes expansion of the piston, which reduces blow-by and noise from piston slap

• Top rings are higher on the piston and a thinner head gasket is used to greatly reduce the volume of unburned waste gases and increase combustion efficiency

• Timing gears and injector drive gears have a helical profile to reduce engine noise

• Auto-bleed fuel system

• There is no need to prime the system if the tractor runs out of fuel

• The system will self-prime the injection pump, lines, and injectors, providing fast fuel recovery for easier starting

• High-capacity lubrication system provides filtered oil, under pressure, to all engine bearings for long life

• Key start and shutoff eliminates fuel shutoff knob

• Electric solenoid shuts fuel supply off immediately when key is turned off, which replaces the need to pull a fuel shutoff lever like many older tractors

• Fuel filter with replaceable element

• Water separator with additional replaceable filter element

• See-through coolant recovery tank permits operator to check coolant level without removing radiator cap

• The 3E Tractors are available with a two-range hydrostatic transmission (HST) incorporated in a die-cast aluminum transmission case. Fluid under pressure transmits engine power to the drive wheels via a closed-loop pump and motor arrangement. Infinite ground speeds allow the operator to match the speed of the tractor to the job.

• No clutching for fast and easy direction changes

• Twin Touch™ foot pedals for quick and easy forward/reverse operation

• Transmission oil cooler cools transmission oil for longer transmission life

• The tractor will only start with the range lever in neutral

• The engine will shut off if the operator leaves the seat unless the range lever is in neutral

• The engine will shut off if the operator leaves the seat and the power take-off (PTO) is engaged

300E Loader + Bucket

Features

    • Compatible with 3025D, 3035D, 3043D, 3025E, 3032E, and 3038E

    • Curved boom design improves operator visibility to front implements

    • Larger knee plates for strength and durability without sacrificing compact stance

    • 977 lbs (444 kg) of lift capacity

    • End-of-pin lubrication - easy maintenance

    • Quick-Change attachment carrier

    • Parking stand kit 


RB2060 Rear Blade

Features

    • iMatch™ compatible

    • Manually adjustable angle

    • Reversible cutting edge

    • Optional end plates 
 

iMatch Quick Hitch

Features

    • Provides easy hookup and a guaranteed fit for all Category 1 implements designed to meet the ASAE
      Category 1 Standard S278.6 for quick-attach hitches.

    • All implements require a set of bushings in order for the attachment to fit and work properly with the
       iMatch Quick-Hitch. One set of bushings comes with the iMatch Quick-Hitch.

NOTE: All implements (box blades, tillers, rear blades, landscape rakes, etc.) require a set of bushings to enlarge the pin to fit with the iMatch hooks.